Saturn Outlook Online Community - Reply to Topic
Thread: 2008 Outlook, steer column Reply to Thread
Title:
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now



In order to be able to post messages on the Saturn Outlook Online Community forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
03-17-2019 11:35 AM
electbc There are very knowledgeable ppl on all 3 of the other boards. Acadiaforum, Traverseforum and Enclaveforum.
03-16-2019 02:49 PM
Matt Myer where is that other board that the gm tech is on?
04-21-2015 08:56 PM
mswerb
Re: 2008 Outlook, steer column

Never take your vehicle to the dealership for a "Noise". Chances are, they won't be able to duplicate the problem. If it isn't a mechanical problem, leave it alone.
04-21-2015 02:55 PM
tsc1969
Re: 2008 Outlook, steer column

No, I never heard from anyone.
Quote:
Originally Posted by Sleonar1
Did you get a response to your lubricate question? I too would like to know
04-21-2015 02:07 PM
Sleonar1
Re: 2008 Outlook, steer column

Did you get a response to your lubricate question? I too would like to know
07-04-2014 08:50 AM
tsc1969
Re: 2008 Outlook, steer column

I also have the "zipper type" sound. Does anyone know if the "dry seal" can be accessed and lubricated?
Tim C.
Quote:
Originally Posted by ls973800

multiple steering issues on traverse, acadia, & enclave models. the "zipper type" noise heard when turning the steering wheel (sometimes quite faint, some are louder, seems to get worse as vehicle is driven longer) is caused by a dry seal at the steering gear input shaft. this is merely an annoyance and presents no safety issue or operational malfunctions. owners of most vehicles that are out of warranty do not repair this.
07-04-2014 12:18 AM
ls973800
Re: 2008 Outlook, steer column

Quote:
Originally Posted by Tracie
I have only had my car for about 4 months. There is a noise when I turn my steering wheel. I thought it was power steering fluid, but then as I lean closer I can hear it, it sound like plastic rubbing? Any similar problems?
Save yourself the dealer fees and see if this will help you determine the cause of your noise. Posted on one of the other boards by a 20 year GM Suspension/Steering/Brakes Tech.

20 year gm technician here, specifically suspension/steering/brakes. made an account just to reply to this thread. i know some of these posts are quite old, but still relevant.

multiple steering issues on traverse, acadia, & enclave models. the "zipper type" noise heard when turning the steering wheel (sometimes quite faint, some are louder, seems to get worse as vehicle is driven longer) is caused by a dry seal at the steering gear input shaft. this is merely an annoyance and presents no safety issue or operational malfunctions. owners of most vehicles that are out of warranty do not repair this.

a LOT of the steering gears leak. about 50% of the ones that do leak probably don't leak bad enough to replace.

the loud/hard clunking noise heard on model years 2010 & prior is due to steering gear mount bushings. the replacement bushings are made of an updated compound. service procedure requires r&r of steering rack/pinion to replace. as bad as the noise can sound, it does not present any safety/operational issues in my opinion.

the intermittent hard steering is an internal steering pump fault probably 95% of the time. the condition can be intermittent, seems to be worse after reaching operating temps/hot. the problem can be duplicated by sitting still & revving the engine 2-3K rpm's while turning the steering wheel. the actual cause is a flow control valve internal to the pump. the valve gets worn on 1 side & bypasses fluid at higher pressures, resulting in no assist.

updated service procedures require flushing & refilling p/s system with dexron vi trans fluid.

ANY time i have had the hydraulic circuit of the p/s system opened, the air in the system is EXTREMELY hard to bleed out. it's a long process & at best will still have some air in it that may take 1000 miles or so to completely remove itself. this can cause some pump whine at times, but mostly (in my experience) causes the steering to shudder or vibrate when making parking lot type maneuvers at low engine rpm's, especially after warmed. this presents no operational/safety issues in my opinion. again....VERY DIFFICULT to correct without driving several hundred miles.

i have never had any failures of the variable assist portion of the power steering.

in summary:
- zipper noise.....no biggie
- rack/pinion leak.....depends on severity
- intermittent no assist....fix it. it will only get worse
- clunking....no biggie, depends on annoyance
- shudder/vibration after repairs....normal, keep driving it a while


hope all of this helps.
07-03-2014 08:48 PM
jcarm75
Re: 2008 Outlook, steer column

As suggested, take it to a GM dealership, expect to pay a diagnostic fee (mine is $115 in SoCal).
07-03-2014 05:38 PM
GM Customer Service
Re: 2008 Outlook, steer column

Have you thought about visiting the dealership about this, Tracie? I understand that you're seeking advice here on the forum, however the dealership may be able to inspect your vehicle to determine where the noise is coming from and make the necessary repairs. If you decide that you'd like to have your local dealer look at this for you, please let us know.

Amber N.
GM Customer Care
07-03-2014 01:55 PM
Tracie
2008 Outlook, steer column

I have only had my car for about 4 months. There is a noise when I turn my steering wheel. I thought it was power steering fluid, but then as I lean closer I can hear it, it sound like plastic rubbing? Any similar problems?

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome