Saturn Outlook Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter #1
I bought a Draw Tite hitch and tryed to install it.
I found that the bolts they supplied fit in the exsisting bumper holes, but not the frame.The holes and nuts welded to the frame rails are a smaller size.
All the bolts supplied are the same size on the instruction sheet.
According to Draw Tite all the mounting areas take the same size??? They said NOT to put in a smaller size !I was able to put in a smaller size
Could my trailer hitch mounting nuts on the frame been installed wrong?
Anyone else have this issue
 

·
Registered
Joined
·
754 Posts
maybe theres something different with 08?

for reference- my 2010 traverse with factory tow package.


 

·
Registered
Joined
·
20 Posts
Discussion Starter #3
I thank you for the photos.
Where my hitch has 2 holes yours has 3.One on each side. of the rail, 2 on the bottom.
The problem is the bolts supplied are too big for the holes.
The bolts fit in the bumper all right , but not the frame rail.
All the bolts are suppose to be the same size.
 
1 - 3 of 3 Posts
Top